Range [0 to 255]. Default is 0. This is used to control the code field in the RRP message sent by the Home Agent to the mobile station. An entry of 0 allows the simulator to function normally with automatic handling of authentication and time sync operations. Code 131 will be returned if authentication fails and code 133 will be returned if a time sync error is detected. Otherwise, code 0 will be returned indicating a successful registration. Non-zero positive values will override normal rocessing to force a specific code in the RRP message regardless of other conditions. The special case value of 1 is used to disable this Home Agent and the Registration Response message.

Range [0 to 65535 sec]. Default is 65535. The default value allows the simulator to automatically reply with the same value requested in the RRQ message for normal operation. All other values limit the registration lifetime contained in the RRP message response and are used to test the mobile stations compliance with the network assigned lifetime. Note (ref: RFC-3344): A value of zero indicates that the mobile node has been deregistered.

Default is 1. This is a protocol behavior test parameter designed to disable (value = 0) advertisements or to send multiple advertisements to the mobile station when the PPP link is established.

Default is 0.01. This is a protocol behavior test parameter designed to control the rate at which advertisements are sent. This parameter applies only if the number of Agent Advertisements is set to a value greater than 1.

Default is 0.01. This is a protocol behavior test parameter designed to delay the first advertisement after the PPP link comes up. This parameter applies only if the number of Agent Advertisements is set to a value greater than 0.

Default is blank or 0.0.0.0 (not set). The default value allows the Foreign Agent Care-of address in the Agent Advertisement to automatically contain the address of the MOB-IP-SIM™ that normally acts as the FA. Entering a specific non-zero address will override the normal address that is advertised in the FA care-of address field.

Default is 9000 seconds per IS-835B. This field defines the maximum period that the Advertisement is considered valid in the absence of further Advertisements. This value is included to test the mobile's action when the timeout expires.

Default is 0. This is a 32-bit number representing the preference level of the Router Address included in the Advertisement. A blank entry is treated as a 0.

Default is OFF. Check this option to require the Challenge Handshake Authentication Protocol. The username and password will be used to authenticate in this case. Applies only to Simple IP. This command is available only in the MIP-5850.

Default is 600 sec. This is the longest lifetime that this agent is willing to accept in a Registration Request. A value of 0xffff indicates infinity. The mobile station is required to re-register when this time expires. This field has no relation to the Lifetime field within the ICMP Router Advertisement portion of the Agent Advertisement.

Default is OFF. ON indicates registration with this foreign agent (or another foreign agent on this link) is required even when using a co-located care-of address.

Default is OFF. ON indicates the foreign agent will not accept registrations from additional mobile nodes.

Default is OFF. ON indicates this agent offers service as a home agent on the link on which this Agent Advertisement message is sent.

Default is ON. ON indicates this agent offers service as a foreign agent on the link on which this Agent Advertisement message is sent.

Default is OFF. ON indicates this agent implements receiving tunneled datagrams that use minimal encapsulation.

Default is OFF. ON indicates this agent implements receiving tunneled datagrams that use GRE encapsulation.

Default is OFF. Previous spec defined this as Van Jacobson bit. ON may be used to check that the mobile station ignores this bit.

Default is OFF. ON indicates this Foreign Agent supports reverse tunneling.