Mobile IP typically uses cdma2000 Service Option 33 or the 1xEV-DO Default Packet Application for data calls. All the normal data call setup parameters on the E5515C apply to mobile IP and are not covered in this manual. The E5515C configuration and connection required to link it to the MOB-IP-SIM are explained here, but the Mobile IP wireless device setup and MOB-IP-SIM configuration are assumed to been completed as described in Chapter 3. The E5515C is also assumed to be set up and ready to handle standard data calls.
Connect the required communications test set, PCs, hubs, phone, and MOB-IP-SIM as diagrammed in Appendix D.
Make sure power is applied to all devices and that the required power-up operations are complete.
Use the E5515C soft menu to navigate to the Data Channel Parameters menu and set the external PDSN address to the MOB-IP-SIM local address previously recorded in section [B] of Appendix E and set the External PDSN State to ON.
The E5515C should indicate that the link to the MOB-IP-SIM is active. You must perform this step each time you reset or turn on the E5515C, either manually or by recalling a register with the External PDSN State set ON.
For hybrid mode (two E5515C sets), synchronize the system time between the sets. On the E5515C with its TRIG IN port connected, navigate to the Cell Info or Access Network Info menu, then to CDMA System Time/Sync Info. Verify that Ext 8960 IP Addr contains the IP address of the other E5515C, then press the Sync To External Server button.
Exit back to the E5515C call processing menu.
This completes the E5515C setup.