Mobile IP Simulator for the Agilent E5515C: User Manual
PrevNext

Appendix D. E5515C Interconnection

Figure D-1. MOB-IP-SIM / E5515C Interconnection diagram

The previous figure shows the typical interconnection required for the MOB-IP-SIM to be used with the E5515C. The MOB-IP-SIM, the E5515C, and a PC are all connected to an Ethernet for normal operation. The Ethernet may be connected to a larger LAN or the public Internet if desired.

During setup, the PC is connected to the serial port in order to configure the MOB-IP-SIM's network parameters; this link may be disconnected for normal operation.

Figure D-2. MOB-IP-SIM / E5515C Interconnection diagram for hybrid mode

The previous figure shows the typical interconnection for hybrid mode. Both E5515C sets are connected to the Ethernet, and one supplies a 10 MHz reference signal and a trigger signal to the other. The remaining connections are the same as for a non-hybrid system.

PrevHomeNext
CD Contents Simulator Configuration Worksheet